China will maintain control over steel production and exports in 2026-2030

China will continue to strictly regulate steel production and prohibit the emergence of illegal new capacities in the period 2026-2030. The decision was confirmed as part of the preparation of the Five-Year Development Plan for the industry, Reuters reports.

The restrictions, first introduced in 2021 to reduce CO2 emissions, were also a response to the prolonged decline in domestic demand caused by the crisis in the real estate market and chronic oversupply.

In the first 11 months of 2025, steel production in China fell by 4% year-on-year, and the annual figure is estimated to fall below 1 billion tons for the first time in six years. The National Development and Reform Commission (NDRC) emphasizes that the raw materials industry, including steelmaking, is facing an imbalance between supply and demand and needs to deepen reforms based on the principle of survival of the fittest.

At the same time, since 2023, China has been actively increasing steel exports, partially compensating for the weak domestic market. This has triggered a wave of trade restrictions in many countries. In response, Beijing announced the introduction of a licensing system for the export of about 300 steel products from 2026.

However, the Japan Iron and Steel Federation is skeptical about the effectiveness of this move. Federation Chairman Tadashi Imai said that the new permits are more likely to be aimed at controlling product quality and are unlikely to significantly limit export volumes or support price recovery. According to him, excess supplies of Chinese steel remain a global problem, particularly due to government subsidies.

Imai, who also heads Nippon Steel, noted that US trade barriers, including increased tariffs, will reduce the company’s profits, although the overall effect has been less than expected. This underscores that even with tighter regulation from China, the impact on the global steel market will remain ambiguous and will depend on actual supply reductions.

In November, Chinese steelmakers reduced steel production by 10.9% compared to the same month last year and by 2.9% compared to the previous month, to 69.87 million tons. The figure has been declining for the sixth consecutive month on a monthly basis and has reached its lowest level since December 2023.

  • Companies

Kametstal has confirmed that its A500C reinforcing bars comply with national standards

In June, the Kametstal Steel Plant confirmed that its A500C-grade reinforcing bars with a periodic…

Thursday July 23, 2026
  • Industry

Kazakhstan aims to establish automotive steel production by 2028

The Kazakhstani steel  company Qarmet plans to commence production of automotive sheet steel and the…

Thursday July 23, 2026
  • Global Market

SSAB increased steel production by 3.3% y/y in 1H2026

The Swedish steelmaker SSAB has published its financial and operational results for the first half…

Thursday July 23, 2026
  • Global Market

Global steel production rose by 1.7% y/y in June

Global steel production in June 2026 rose by 1.7% year-on-year – to 155.7 million tonnes.…

Thursday July 23, 2026
  • Global Market

Kardemir Çelik is launching an IPO to raise working capital

The Turkish steelmaker Kardemir Çelik Sanayi A.Ş. has announced that it is preparing to enter…

Thursday July 23, 2026
  • State

The ECA supported Ukrainian exports to the tune of 7.5 billion UAH in 1H2026

The Export-Credit Agency of Ukraine (ECA) supported exports of Ukrainian goods worth 7.53 billion UAH…

Thursday July 23, 2026